ACSD-66/80 Digital Brushless AC Servo Drive system - Ref.1609
Function Cutoff frequency of the first-order low-pass filter after the
velocity feedback.
Valid values 0 (the filter is not applied) ... 4 000 Hz.
Default value 800 Hz.
Function Determines the value of the acceleration ramp applied to
the velocity command. Setting it with a zero value means
that no ramps will be applied.
Valid values 0.0 ... 400.0 rpm/ms.
Default value 0.0 rpm/ms.
Function In emergency stop. If the bus voltage drops or there is a
power outage for the unit in the acceleration, deceleration or
constant power mode, The drive will always issue an E.003
or E.307 error and will enter into a dynamic braking sequence
without warning the CNC (DV32.13=0) or sending the
warning “WarningMainsLine” (DV31.10) to the CNC two
seconds before (DV32.13=1. It stops with the emergency
ramp until its speed is zero as long as the mechanical energy
stored in the motor allows it. Therefore, it limits the command
acceleration for stopping the motor.
SP50 BASIC, RW S34782 VelocityFeedbackFilterFrequency
SP60 BASIC, RW S00138 AccelerationLimit
SP65 BASIC, RW S34377 EmergencyAcceleration
SV7
SV2
1Vpp
encoder
SP50=0
SP50>0
Low-pass
filter
fc=SP50
To Next Page
Loading...
