Faraday MPC-6000 - Event History

To Next Page

To Previous Page

MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL

EVENT HISTORY

The control unit includes a non-volatile memory recording over 1900 system events. Identified

alarm, trouble, supervisory trouble and other significant events will be recorded along with the

date and time of occurrence and can be inspected by operating front panel push buttons.

Events recorded in the history are:

 Alarm, Trouble or Supervisory conditions.

 Drill, Recall and General Evacuation.

 Activation of NACs or modules used for sounders or strobes.

 Unit used for command functions (Silence, acknowledge, reset, etc.).

 Alarm silence (Manual).

 System reset.

 Power up.

 Entry to Programmer Mode.

 Back-up configuration edited.

 Validity check on backup configuration (Errors detected or no errors detected).

 Replacement of primary configuration.

 Execution of Auto-program.

 Exit from Programmer Mode.

 System time or date change.

 Input point disable/enable.

 Start and stop of Quick Test.

 Expiration of Quick Test Timer.

 Trouble/supervisory reminder.

 Alarm/trouble/supervisory Acknowledgment.

 Trouble/supervisory restored to normal.

 Pre-alarm activation.

 Pre-alarm acknowledgment/restore.

 Activation of points defined for logging.

 Pre-discharge condition (Applicable to MPC-6000 with Releasing application only).

 Discharge condition (Applicable to MPC-6000 with Releasing application only).

 Abort condition (Applicable to MPC-6000 with Releasing application only).

 Manual Fan Restart.

Other manuals for Faraday MPC-6000