Faraday MPC-6000 - Additional Operating Procedures; Lamp Test, Drill, Recall, Alert

MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL
26
ADDITIONAL OPERATING PROCEDURES
In addition to the basic fire alarm instructions above, several features are included to facilitate
maintenance and increase the versatility of the system. Following are procedures to call up these
functions.
Lamp Test
When selected, Lamp Test activates the buzzer and turns on all the LEDs on the user interface for 2
seconds, then reverts to its previous state.
To initiate a Lamp Test, proceed as follows:
 Press "MENU".
 On the MENU display, select "More".
 On the next screen, select "More" again.
 Select Lamp Test to initiate the lamp test sequence.
 Select “Esc” to return the control unit to normal display.
Note that lamp test operates the indicators only on the units being operated and no record is reported
to system history.
Drill
When selected, activates all NACs assigned to the Output Zone selected for “Drill”.
To activate a fire alarm drill, proceed as follows:
 Press "MENU".
 On the MENU display, select "More".
 At the next screen, select "DRILL".
 At the next screen, select "Yes".
 Operate RESET to terminate drill signal.
Recall
When selected, activates all NACs assigned to Output Zones selected for “Recall”.
To signal recall after a drill, proceed as follows:
 Press "MENU".
 On the MENU display, select "More".
 Select "RECALL".
 At the next screen, select "Yes".
 Operate RESET to terminate recall signal.
Alert
When selected, activates all NACs assigned to the Output Zone selected for “Alert”.
To activate an alert alarm, proceed as follows:
 Press "MENU".
 On the MENU display, select "ALERT".
 At the next screen, select "Yes".
 Operate RESET to terminate alert signal.