MPC-6000 / MPC-7000 / RND-2 INSTALLATION, OPERATION AND MAINTENANCE MANUAL
55
MAINTENANCE
GENERAL
The MPC-6000 / MPC-7000 / RND-2 provides a maintenance mode to allow for the setting and
controlling of various features in the system. Since the RND-2 does not have devices
connected to it, some of these functions are not available on the RND-2.
The maintenance functions are protected by a four digit password. To access the maintenance
features press the “MENU” button until “Maint. Level” is displayed and select “Maint. Level”
from the display, enter the four digit code when prompted and then press “Enter”. The
functions listed below are now accessible to the user by using the function buttons on either
side of the display.
Disable/Enable Devices
Disable/Enable Input Groups
Disable/Enable Output Zones
Disable/Enable NACs
Disable/Enable City Tie
Disable/Enable DACT
Disable/Enable Status Relays
Disable/Enable Detector Applications
Disable/Enable PAS
Disable/Enable Open Collector Circuit*
Disable/Enable Releasing Circuit*
Starting and Configuring Quick Test
Print/Clear History Log
Print Sensor Levels
Edit Device Labels
Edit System Labels
Program a Device
Set the Time
Set the Date
Change the Maintenance Password
*For MPC-6000 only when MPC-REL is installed.
Disabling any input and output devices, modules and applications will annunciate a
trouble condition.
Exception: Disabling the Releasing Circuits using the disable switch on MPC-REL
will annunciate a supervisory condition.
Refer to the Programming Manual, P/N 315-049403FA, for more information about accessing
and using the maintenance level functions.
To Next Page
Loading...
