2. Installation
2−3
Festo P.BE−CPX−CEC−EN en 1004a
2.1 General installation instructions
Warning
Danger of injury from electric shock.
· Always switch off the power supply before fitting or
removing CPX modules.
Caution
The CoDeSys controller contains electrostatically sensitive
components.
· Therefore, do not touch any contacts.
· Observe the handling specifications for electrostatically
sensitive devices.
Note
Check within the framework of your EMERGENCY STOP
concept to ascertain the measures necessary for putting
your machine/system into a safe state in the event of an
EMERGENCY STOP (e.g. switching off power sources,
load voltage supply, compressed air, etc.).
Information on fitting the CPX terminal can be found in the
CPX system
manual type P.BE−CPX−SYS−... .
To Next Page
Loading...
