–
During rapid movement of heavy masses, especially during braking, the pressure in the pneumatic
system can increase and damage pneumatic components.
–
Set up the pneumatic installation with sufficient load reserve for the application.
–
Store the product in a cool, dry environment protected from UV and corrosion. Keep storage times
short.
–
Comply with the handling specifications for electrostatically sensitive devices.
–
Observe tightening torques. Unless otherwise specified, the tolerance is ± 20 %.
2.2 Intended use
The product is intended for controlling pneumatic drives and for implementing motion tasks (Motion
Apps).
The product may only be used as follows:
–
Use only in an industrial environment: outside industrial environments, e.g. in commercial and
mixed-residential areas, action to suppress interference may have to be taken.
– Use exclusively in combination with modules and components that are certified for the specific
product variant and have been tested and approved by Festo.
– Use in technically perfect original status without unauthorised modifications. Only the conversions
or modifications described in this and the further applicable documents are permitted.
2.3
Training of qualified personnel
Installation, commissioning, maintenance and disassembly should only be conducted by qualified
personnel.
The specialized personnel must be familiar with the installation and operation of electrical and
pneumatic control systems.
3
Function
3.1
General
The Motion Terminal VTEM provides a range of pneumatic open-loop and closed-loop control functions
that are executed in the form of Motion apps (MA). Parameters and setpoint values for executing a
Motion App can be specified. The Motion App converts these specifications into control commands at
the corresponding valve.
3.1.1 Product design
The product can consist of the following modules, depending on the configuration ordered:
To Next Page
Loading...
