2. Fitting
2−3
Festo P.BE−VTSA−44−EN en 0509NH
Contents of this chapter The VTSA valve terminal is already assembled when supplied
from the factory.
This chapter describes how to fit and remove:
the complete valve terminal (hat rail or wall fitting)
the mounting bracket for wall fitting
the inscription labels
the manual override caps.
Further information Special information on replacing or adding pneumatic compo
nents
can be found in chapter 5.
VTSA valve terminal with CPX terminal:
Information on fitting the valve terminal with CPX terminal
can be found in the CPX system manual.
Information on fitting and dismantling the I/O modules
can be found in the manual for the CPX I/O modules.
Information on fitting modules and
components ordered
at a later stage can be found in the leaflet supplied with
the product.
To Next Page
Loading...
