Festo VTSA-FB - Fitting Onto;Removing from a hat Rail

2. Fitting
2−8
Festo P.BE−VTSA−44−EN en 0509NH
4. Fit the hat rail clamping units (see Tab.2/2).
5. Hang the valve terminal onto the hat rail (see Fig.2/1,
arrow (A)).
6. Swing the valve terminal onto the hat rail (see Fig.2/1,
arrow (B)). Make sure that the clamping element lies
horizontally to the hat rail.
1 Hat rail
2 Locking screw of
the hat rail
clamping unit
3 Clamping element
of the hat rail
clamping unit
(A)
(B)
1
2
3
Fig.2/1: Fitting the VTSA valve terminal onto a hat rail
7. Secure the VTSA valve terminal, as with the CPX terminal,
against tilting or sliding by tightening the locking screw
with 1.3 Nm.