3. Installation
3−3
Festo P.BE−VTSA−44−EN en 0509NH
Contents of this chapter This chapter describes the tubing and cabling of the VTSA
valve terminal. The following in particular belong here:
General instructions on preparing the compressed air and
on connecting the tubing
Instructions on pilot control of the valve solenoid coils
with internal or external pilot air
Instructions on operating the valve terminals
with
pressure zones
Instructions on operating the valve terminal with
reversible 2x3/2−way valves
Fitting the QS screw connectors
Connecting the power supply
Earthing the valve terminal
Address assignment of the valves
Further information Instructions on connecting the electrical components of the
VTSA valve terminal with multipin node can be found in the
relevant information supplied with
the product.
Instructions on connecting the operating voltage for the
VTSA valve terminal with CPX terminal can be found in
chapter 3 of the CPX system manual.
Detailed instructions on connectiing CPX modules (field bus
nodes, I/O modules, etc.) can be found in the relevant man
uals for the CPX module.
To Next Page
Loading...
