Fimap MAGNA - Preparation of Machine for Operation; Machine Safety Measures

PREPARATION OF MACHINE
MACHINE SAFETY
To ensure that work is carried out in the best safety conditions, proceed as follows:
1. Make sure the solution tank is empty. If this is not the case, empty it (read "EMPTYING THE SOLUTION TANK").
2. Make sure the recovery tank is empty. If this is not the case, empty it (read "EMPTYING THE RECOVERY TANK").
3. Sit on the driver’s seat.
4. Insert the key (1) into the main switch on the control panel. Set the main switch to "I" by turning the key a quarter turn clockwise (Fig. 1).
5. Turn the brush head control lever (2) anti-clockwise (Fig. 2); in this manner the brush head body will be raised o󰀨 the oor.
6. Turn the squeegee control lever (3) clockwise (Fig. 3) to raise the squeegee body o󰀨 the oor.
7. Set the main switch to “0" (Fig. 4) by turning the key (1) a quarter turn anti-clockwise. Remove the key from the instrument panel.
8. Get o󰀨 the machine.
CAUTION: when getting down from the machine, do not place your foot on the scrubbing brush head or side brush head brush.
9. Grip the back of the seat (4) and turn the seat support plate to its maintenance position (Fig. 5).
ATTENTION: to prevent the seat from rotating, insert the retainer (5) into the slot (6) (Fig. 6).
10. Disconnect the battery connector from the machine's main system connector (Fig. 7).
11. Grip the back of the seat (4) and turn the seat support plate to the working position.
N.B.: before rotating the seat support plate, remove the retainer (5).
14
30
31
32
34
33
30
32
31
27 2928
27
26
28
29
26
25
23
23
24
24
25
2221
25
22
23
20
24
19
18
22
23
17
21
20
16
19
17
18
16
13
14
13
11 1210
10
11
12
13
1514
8 9
15
7
13
9
8
2 3
2
3
1
1
6
5
6
7
4
5
1
4