3-13
3.3 Drying system: what to do if. . .
The machine doesn’t dry well
1 The machine is switched off ⇒ Switch on the machine.
2 The machine doesn’t switch on ⇒ Refer to the proper section (see section
3.1 at page 9).
3 The squeegee is lifted up from the
floor
⇒ Lower down the squeegee.
4 The squeegee rubber blades are
worn out or broken
⇒ Rotate or replace the squeegee rub-
ber blades.
5 The recovery tank is full ⇒ Empty the recovery tank following
the proper procedure.
6 The squeegee is not properly ad-
justed
⇒ Adjust the squeegee properly follow-
ing the proper procedure (see section 7.3.1
at page 58).
7 The squeegee vacuum chamber is
stuck or dirty
⇒ Clean the squeegee vacuum cham-
ber.
8 The squeegee adapter is stuck or
dirty
⇒ Clean the squeegee adapter.
9 The vacuum hose is stuck or bro-
ken
⇒ Clean or replace the vacuum hose.
10 The vacuum hose is not properly
fitted in
⇒ Connect the vacuum hose properly.
11 The vacuum filter is dirty or stuck ⇒ Disassemble and clean the vacuum
filter.
12 The vacuum cover is not well posi-
tioned or is missing
⇒ Position properly the vacuum cover.
13 The vacuum cover gasket doesn’t
adhere properly
⇒ Replace the vacuum cover gasket.
To Next Page
Loading...
