56
CONTROL PANEL GUIDE AND SYSTEM OPERATION (CONTINUED)
OPTIONS SCREEN - REGENERATION (CONTINUED)
STATIONARY REGENERATION BY ENGINE MANAGEMENT
If the ECU determines that performing the Stationary Regeneration is required, the operator
will be alerted via the control panel that a Stationary Regeneration is required via a Diagnostic
Trouble Code (DTC) even if Regeneration on the control panel is set to Inhibit. The operator
should immediately conduct the Stationary Regeneration by performing the following operation.
1. Move the
machine to a
well-ventilated
and safe
location.
2. Press REGEN
softkey.
3. Press the
HYDRAULIC
INTERLOCK
softkey.
To Next Page
