FIOCCHETTI 130 - Request for Technical Support; Safety; General Safety Rules; Safety and Accident Prevention

MNL004_EN rev. F
Pag. 7 di 56
1.5 REQUEST FOR TECHNICAL SUPPORT
Provide all the information required regarding operation of the device being tested in order to request technical support
from FIOCCHETTI.
For this purpose, send the table in Annex 1 (pag. 53) “USER DATA FOR TECHNICAL SUPPORT REQUEST”
filled in.
Technical support department e-
mail
assistenza@fiocchetti.it
Sales department e-mail
commerciale@fiocchetti.it
Support request
http://www.fiocchetti.it/it/tecnico-frigo.asp
User manual request
http://www.fiocchetti.it/it/manuali-frigoriferi-congelatori-
emoteche.asp
Tel.
+39 0522 976232
Fax
+39 0522 976028
Our Technical Support Department can provide all the information you need for correct unit operation and can put
you in touch with your nearest authorised service centre. Our Sales Department staff provides information on prices
and availability of requested components.
2 SAFETY
2.1 GENERAL SAFETY RULES
Read the manual carefully and follow instructions contained herein. Do not use the equipment for purposes other than
those for which it was designed.
The user assumes full responsibility in case of operations carried out without observing the instructions in the manual.
Below is a list of the main safety rules:
- Do not touch the equipment with moist or wet hands or feet.
- Do not insert screwdrivers or other objects into the guards or moving parts.
- Do not pull the power cord to disconnect the appliance from the electrical mains.
- Do not allow the machine to be used by unauthorised users.
- Before performing any cleaning or maintenance, disconnect the machine from the electrical mains by switching it
off and disconnecting the plug.
- In case of failure and/or malfunction, switch off the machine and do not attempt to repair or service it on your
own. It is absolutely necessary to contact qualified personnel.
2.2 SAFETY AND ACCIDENT PREVENTION
This machine has been designed with suitable measures to assure safety and the health of the user. The following is a
list of protections adopted against mechanical risks:
- Stability: the machine has been designed and built in order to guarantee its stability in all foreseen operating
conditions, even with shelves/drawers extracted, without any risk of tipping, falling, or sudden movement.
- Surfaces, edges, corners: within the limits permitted by their functions, accessible parts of the machine have no
sharp corners, sharp edges or rough surfaces that could cause injury.
- Moving parts: all components with the possibility of movement have been designed, built and configured to avoid
risk. Some parts are also protected by fixed guards to prevent contact or injury.
The following is a list of measures adopted to protect against other risks: