General operation
14.7.16 Kapitel/Chapter 13: General operation - Seite/Page 137
Display screen for single phase generators
Fig. 13.3.3.4-2: Inverter screen in operation modeWith the single phase i-series generators, there is an
additional screen in operation mode for the inverter data.
This screen provides the current inverter output voltage
and the inverter temperature. You can access the
inverter screen by actuating the cursor-up button while
in operation mode.
Display screens for 3-phase generators
Fig. 13.3.3.4-3: Inverter screen coil-voltage and conductor currentWith the 3-phase i-series generators, there are 5 additional
screen in operation mode for the inverter data. This screen
provides the inverter coil-voltage and the conductor current.
You can access the inverter screen by actuating the cursor-
up button while in operation mode.
Fig. 13.3.3.4-4: Inverter screen phase voltagesThis screen provides the latest inverter phase voltages. You
can access the inverter screen by actuating the cursor-up
button while in operation mode.
Fig. 13.3.3.4-5: Phase voltage L1This screen provides the latest inverter output voltage of the
single phases with the matching conductor current and the
circuit board temperature. The inverter will be switched off at
a circuit board temperature of 75 °C. You can access the
inverter screen by actuating the cursor-up button while in
operation mode.
Fig. 13.3.3.4-6: Phase voltage L2This screen provides the latest inverter output voltage of the
single phases with the matching conductor current and the
circuit board temperature. The inverter will be switched off at
a circuit board temperature of 75 °C. You can access the
inverter screen by actuating the cursor-up button while in
operation mode.
To Next Page