Maintenance Instructions
Seite/Page 84 - Kaptitel/Chapter 8: Maintenance Instructions 14.7.16
Fig. 8.11.2-1: Fuel return pippe1. Put a container under the fuel return pipe to catch running
out fuel to catch.
2. Switch the panel „ON“.
3. Activate the the fuel pump prime function in the panel
menue.
4. Let the pump run till the fuel runs bleed free out of the
return line. (about three times activation of the fuel pump
prime function)
Fig. 8.11.2-2: iControlThis procedure must be repeated several times, until fuel
(nonporously) withdraws perfectly at the fuel return pipe.
5. Switch the panel „OFF“.
8.11.3 Replacement of the air filter
Fig. 8.11.3-1: Air filterOpen the air suctin housing by loosen the six hexagon
head screws on the frame cover.
To Next Page
Loading...
