Flexim FLUXUS G801 - Page 33

6 Mounting
FLUXUS G801 6.2 Transducers
33
UMFLUXUS_G801V1-0EN, 2020-06-26
• Depending on the transducer type, it can be necessary to mount additional layers of damping mats (see technical
specification, section "Damping mats"). Repeat the steps for mounting the damping mats.
• If possible, make sure not to mount the transducers on the seams between the damping mats. If the transducers are
mounted on the seams, there must be no gaps between the damping mats, i.e. the damping mats have to be installed
edge to edge.
Fig. 6.6: Mounting of the damping mats
a)
b)
c)
(2)
(1)
(2)
(1)