6 Mounting
FLUXUS G801 6.2 Transducers
39
UMFLUXUS_G801V1-0EN, 2020-06-26
6.2.3.3 Mounting the transducers of type ****LI**
If the nameplate of the transducers ****LI** is removed from the transducer cable during installation, it has afterwards to be
remounted and fixed to the transducer cable using the provided cable tie. The heat shrink tubing must not be reused.
Fig. 6.11: Nameplate on the transducer cable
1 – transducers
2 – nameplate
3 – heat shrink tubing
4 – cable tie
before mounting: after mounting:
1 1
2 2
3
4
To Next Page
