Flintec FT-112 - Page 151

FT-112(D) Panel Weighing Indicator, Technical Manual, Rev.1.0.0, May 2019 Page 150 of 170
11000
24
SetPoint-4 Low
11001
25
SetPoint-5 Low
11010
11110
26
30
Not used
11111
31
Use the Expanded Command list
(Refer to Table 15-3)
B5 ... B1
Read Data
Selection
00000
0
Actual weight (Net if the indication is in Net)
00001
1
Gross weight
00010
2
Tare weight
00011
3
ALL Status (Refer to Table 15-1)
00100
4
Calibration Status (Refer to Table 15-2)
00101
5
Last print value
00110
6
Quantity of M+
00111
01010
7
10
Not used
01011
11
CN (Label number)
01100
12
Totalization of M+
01101
13
Grand Total
01110
14
Not used
01111
15
B. weighing
Filling
C.weighing
Classifying
Peak hold
SetPoint-1
Target
Target
Target
Follow
10000
16
SetPoint-2
Coarse
Low
--Low
Mid Decr.
10001
17
SetPoint-3
Fine
High
-Low
End Decr.
10010
18
SetPoint-4
TareMin
Empty
+High
Stop
10011
19
SetPoint-5
TareMax
Not used
++High
Alarm
10100
20
Not used
Empty
Not used
Empty
Empty
10101
21
SetPoint-1 Low
Only available for Threshold and
Window feature.
Refer to sub-block 36-, page 61 to
see the availabilities.
10110
22
SetPoint-2 Low
10111
23
SetPoint-3 Low
11000
24
SetPoint-4 Low
11001
25
SetPoint-5 Low
11010
11110
26
30
Not used
11111
31
Use the Expanded Command list
(Refer to Table 15-3)
B0
New CMD
Toggle
Apply commands which are listed in this table.
(1) Write this command after writing values to 1
st
Dword, then apply this command with New CMD