436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
and file transfer, as well as video output testing with an analog video monitor. Analog video output
is accessed by connecting the yellow RCA pigtail to a video display. Digital video is not accessible
from the miniUSB port, but can be displayed using the microHDMI port.
The Bench Cable can also be used for connecting FLIR Duo to standard Radio/Control (R/C) Pulse
Width Modulation (PWM) outputs. See Table 1 for pin definitions.
Connecting to a MAVLink-compatible autopilot is possible by building a customized cable based on
accessing miniUSB pin1 and pin3 for MAVLink TX and RX. The MAVLink interface operates at a
default data rate of 57.6 kbps, with the ability to switch to 115.2 kbps, 230.4 kbps through the user
App. See Section 6 for more information.
Figure 2. Bench Cable
To Next Page
Loading...
