FLIR Duo - MSX Image Enhancement; MSX Strength; Alignment; Recommended MSX Alignment Procedure

FLIR Duo User Guide
436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
9
cable that can be used to integrate Duo to your airframe. Please refer to the Duo Technical Drawing
for electrical interface guidelines and USB connector pinout.
Simply plug the chosen cable into the mini-USB port on the FLIR Duo, connect power to an
appropriate filtered and regulated power supply, and video to a downlink, if desired. Approximate
operating current of the Duo camera is 440 mA at 5Vdc, (2.2 Watts). Peak current can reach as high
as 660 mA (3.3 Watts).
Note: FLIR Duo has over-voltage and reverse polarity protection on power pins. However,
exceeding the wide voltage specification (5-26 Vdc) will damage the camera and void the warranty.
Applying reverse polarity should not damage the unit, but it will prevent the camera for powering on
and is not recommended.
Figure 4: Mini-USB 10-pin Layout
Table 1: Mini-USB Port 10-pin Assignment
Mini-USB Port
Bench Cable Internal Wire Color
2
Main Power
red
4
Data Low
white
6
Data High
green
8
Reserved
10
Main Power GND
black
1
PWM_1 / MAVLink TX Out
yellow
3
PWM_2 / MAVLink RX In
purple
5
Video Low
7
Video High
Top
Side
WIRING