436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
4.3 Software Interface
The Duo camera is configured and operated through the FLIR UAS mobile device app. See Section 5
for additional details.
Note: The Duo camera is not compatible with the FLIR Camera Controller User Interface software.
When connected to the USB port on a computer, the camera appears as a mass storage device only.
There is no Software Developer’s Kit or API available for the camera. However, advanced camera
control can be arranged using PWM, MAVLink, or TCP/IP integration (see Section 6).
4.4 Camera Operation
Figure 5. Camera Status and Record LED Description
The Duo does not have an on/off switch. When power is applied the camera will boot automatically;
this takes less than 30 seconds.
When power is applied to the camera, the Status LED blinks red for approximately 20
seconds, then changes to solid blue, indicating that Bluetooth is enabled.
Record LED – Off and then Orange flashing
Status LED – Red flashing
Bluetooth Status
Status LED – Green for Bluetooth off
Status LED – Blue for Bluetooth on
Record ability
Record LED – Green: Ready to Record
Record LED – Red flashing: Actively Recording
Firmware Update
Status LED – Purple flashing
To Next Page
Loading...
