436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
Figure 14. About Page
Scan for Camera: Searches for any FLIR UAS camera in the area and
provides user ability to change cameras.
USB Interface: Use this setting to select between USB Mass Storage mode
(the default setting) and Ethernet mode. Recommended for advanced
users only – see section 6 for more detail on controlling the camera via a
virtual Ethernet connection.
USB Boot Mode: Sets which USB Interface mode the camera is defaulted
to upon power-on.
Persistent Bluetooth – Prevents the Bluetooth interface from shutting
off after 2 minutes by keeping the APP active.
Bluetooth Power – Adjusts the Bluetooth transmitter power and affects
the maximum range at which the Duo camera can connect to the mobile
device. Power values are expressed in percent.
To Next Page
Loading...
