FLIR Duo - Display Video Mode

FLIR Duo User Guide
436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
11
 The Record LED will go from blinking orange to solid green, indicating that the camera is
ready for operation
o Note 1: If connected to a computer, the “Record” LED will continue blinking orange,
indicating that the device is in “USB Mass Storage” mode
o Note 2: If “Record” LED continues blinking orange while connected to a battery or
bench power supply, this indicates that there is no SD card in the camera
 Launch the FLIR UAS app on your mobile device.
o Use the app to configure camera settings as desired
 See Section 5 for information on camera settings & operating modes
o Disable the Bluetooth radio in preparation for flight
 Simply press the Bluetooth button on the side of the Duo, and confirm that the
Status LED turns green
 The Duo will automatically disable the Bluetooth radio after 2 minutes if no
commands are received from the app. It can be re-started by pressing the
Bluetooth button on the camera
Note: The Bluetooth interface is only intended for use during ground operations. FLIR does not
recommend flying while Bluetooth is enabled. Bluetooth interface has limited range and high latency.
 Your FLIR Duo is now ready for use. Press the Record button on the camera or in the app to
start recording, or use PWM signals. The “Record” LED blinks red while recording video, or
flashes red each time it captures a still image.
4.5 Camera Troubleshooting
 The Duo can be rebooted & reset to factory defaults through the FLIR UAS App
o With the App connected to the Duo, go to:
 “Settings” -> “About” -> “Reset To Factory Defaults”
 To reboot the system manually:
o Press and hold the “Record” button on the Duo for at least 5 seconds
 To reboot and perform a factory reset to all default settings manually:
o Press and hold both the “Record” and “Bluetooth” buttons for 10 seconds