436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
6.3 TCP/IP
For all Duo FW versions 2.1.4 or later, the camera now supports a TCP/IP communication protocol
for command/control and small file transfer over USB.
To enable TCP/IP communication with your Duo, set “USB Interface” to “Ethernet” with the mobile
APP or over MAVlink, and then send commands from your host computer. The TCP/IP and MAVlink
interfaces can operate simultaneously, and provide complementary functionality in a fully
integrated system.
Please see Appendix C for the TCP/IP protocol implementation.
To Next Page
Loading...
