436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
8 Care of FLIR Duo
Power your FLIR Duo with a regulated 5-26 Vdc power source. Using more than 26 Vdc will
damage the camera and void the warranty.
Do not touch the lens. If the lens gets dirty, a light dusting of air should dislodge any dust
particles. If the lens is still noticeably dirty, use 75% Isopropyl alcohol and lens tissue. Use
light wiping motions with a fresh section of lens tissue with each swipe so as not to drag dust
or dirt particles back over the lens surface.
FLIR Duo cameras have been focused at the factory and optimized for the maximum UAS
range. Opening the camera may compromise the external seal of the camera, and factory
focus will be lost. This also voids the camera warranty.
The FLIR Duo is neither water nor dust resistant. Care for it as you would any valuable piece
of electronics equipment.
If you have questions about your Duo camera, contact FLIR Tech Support
at 1-866-667-7732.
To Next Page
Loading...
