FLIR Duo - PWM, MAVLink, and TCP;IP Operation; PWM; Connecting to a PWM Compatible Flight Controller

FLIR Duo User Guide
436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
20
 Capture Mode: Select the recording mode: video, still, or multiple.
 Photo Format: Select formats for still images and video saved to the
µSD card (See Section 7)
 IR Video Format: Infrared video can be saved as 8-bit (H264) that
has FLIR AGC (automatic gain correction), MSX, Spot Meter (Duo R
only), and color palette applied, or 14-bit (TIFF Sequence) raw
sensor data. See Section 7 for more details.
 Recorded Video: This setting determines the type of sensor data that
is saved to the µSD card. The Duo can be setup to record Visible Only,
IR Only, or IR & Visible.
 Sound When Start/Stop Record: Turns on/off the audible indicator
for video recording. Even when turned off, the speaker will beep three
times when the camera is ready after power-up.
 Status Light: Turns on/off the Status and Bluetooth LEDs. LED
indicators will still be displayed while camera is booting up, even if
this setting is turned off.
 Camera Orientation Flip: Select image orientation. If the camera will
be mounted upside-down, enable this setting to vertically flip the
images recorded by the Duo.
 Color Palette: Select the IR color palette
 Radiometry (Duo R only): Enter the Radiometry parameter
adjustment menu
 Spot Meter (Duo R only): Enable on-screen spot meter that shows
the temperature of the object in the center of the image
 Analog Output Format: Select NTSC or PAL as the format of the video
that is output to the 10-pin mini USB port. This setting does not affect
the format of the video that is saved to the microSD card.