FLIR Duo - Page 54

FLI R Duo User Guide
436-0100-01-10, Rev. 200 Duo User Guide
Information on this page is subject to change without notice
49
CRC1 / Reserved : Reserved field. In CSP-UART applications, for CRC check (from the beginning of the code, the checksum is calculated using the CRC16-
CCITT standard in bytes 1 to 6 ); this field can be ignored in CSP-TCP applications
message body: see the next chapter
CRC2 / Reserved : Reserved field. In CSP-UART applications, a CRC check (identification code from the beginning, in bytes . 1 ~ N + . 8 ) using CRC16-
CCITT standard checksum calculation ); in CSP-TCP applications can ignore this field
[Comment]: CRC16 polynomial = x
16
+ x
12
+ x
5
+1
Status Code
status code
Description
0x00
success
0x02
Operation error
0x03
The instruction number is incorrect
0x04
Parameter is illegal
0x05
CRC1 check code error
0x06
CRC2 check code error
0x07
The file could not be found
0x08
The device is busy and can not respond
Network Configuration
Network
Configuration
Description
IP address ( USB )
192.168.10.19
Control command
port
6000 , TCP short connection for camera control and parameter configuration, and
other messages
Event port
6002 , TCP long connection for camera event notification
【Note】:
Equipment as a server, network communication are used TCP request - response mode.