■ When you save an image, the zoom factor will be saved too. When you open such
an image in ThermaCAM™ QuickView or ThermaCAM™ Reporter, you can change
the zoom factor again.
8.8.4 Inserting & removing the battery
➲ The camera is shipped with charged batteries. To increase the battery life, the
battery should be fully discharged and charged a couple of times. You can do this
by using the camera until the battery is fully depleted.
8.8.4.1 Inserting the battery
10396403;a2
Figure 8.3 Inserting the battery
ActionStep
Remove lid of the battery compartment by pressing the locking mechanism.1
Insert the battery with the connectors facing the rear end of the camera and the
arrow symbol facing the front end of the camera.
2
Replace the lid of the battery compartment.3
8.8.4.2 Removing the battery
10396503;a2
Figure 8.4 Removing the battery
8
54 Publ. No. 1558407 Rev. a155 – ENGLISH (EN) – February 6, 2006
8 – Tutorials