To Next Page

To Previous Page

Example command: SYST:CONF:PDEV?

Example response: 1

6.5.8.17 SYSTem:CONFigure:PRINter[n]:DADDress?

This query command returns the device address (number of the device within

its module) of a given printer device. The printer device number is given by the

PRIN suffix n. Printer devices are assigned numbers sequentially starting with

1. The command SYST:CONF:PDEV? (Section 6.5.8.16) can be used to deter

mine the number of installed printer devices.

Example command: SYST:CONF:PRIN1:DADD?

Example response: 4

6.5.8.18 SYSTem:CONFigure: PRINter[n]:MADDress?

This query command returns the module number or address of the module that

contains a given printer device. The printer device number is given by the PRIN

suffix n. Printer devices are assigned numbers sequentially starting with 1. The

command SYST:CONF:PDEV? (Section 6.5.8.16) can be used to determine the

number of installed printer devices.

Example command: SYST:CONF:PRIN1:MADD?

Example response: 3

6.5.8.19 SYSTem:MODule[n]:DEVice[n]:READ? <device_command>

This query command is used to read configuration parameters directly from a

device. The device is specified by module number and device number. The

module and device numbers are given by the MOD suffix and DEV suffix re-

spectively. The command SYST:CONF:MNUM? (Section 6.5.8.8) can be used

to determine the number of installed modules and the command

SYST:CONF:MOD[n]:DNUM? (Section 6.5.8.10) can be used to determine the

number of devices within a module. The <device_command> parameter is the

command string (enclosed in quotes) passed to the device. Each device has a

unique set of commands (refer to the operating instructions for a specific mod

ule for a list of its device commands). The response type can be either a nu

meric value or character data depending on the device command.

Example command: SYST:MOD2:DEV1:READ? “CURR”

Example response:10

6.5.8.20 SYSTem:MODule[n]:DEVice[n]:WRITe <device_command>,<value>

This command can be used to directly send a command to a device to set a con

figuration parameter. The device is specified by module number and device

number. The module and device numbers are given by the MOD suffix and

DEV suffix respectively. The command SYST:CONF:MNUM? (Section

6.5.8.8) can be used to determine the number of installed modules and the com

mand SYST:CONF: MOD[n]:DNUM? (Section 6.5.8.10) can be used to deter

1560 Thermometer Readout

User’s Guide

Fluke 1560 Black Stack User Manual

Questions and Answers: