SELECT THE CHANNEL TO COPY FROM
>SPRT 01, PROBE 566-011
SPRT 02, PROBE 566-012
TCS 03, PROBE 1341
TCS 04, PROBE 1342
TCS 05, PROBE 1343
TCS 06, PROBE 1344
$
After the source channel is selected, a window appears requesting you to select
the destination channel. The destination channel is selected using the UD
buttons and pressing ENTER.
SELECT THE CHANNEL TO COPY TO
>SPRT 01, PROBE 566-011
SPRT 02, PROBE 566-012
TCS 03, PROBE 1341
TCS 04, PROBE 1342
TCS 05, PROBE 1343
TCS 06, PROBE 1344
$
After the destination channel is selected, a window appears requesting you to
confirm the action. Press ENTER to proceed with copying the parameters or
press EXIT to cancel the operation. If ENTER is pressed, the probe parame
-
ters will be copied from the source channel to the destination channel.
PARAMETERS FOR SPRT 01 WILL BE
OVERWRITTEN.
PRESS ENTER TO PROCEED OR
PRESS EXIT TO CANCEL.
If the source channel type and the destination channel type are incompatible
(e.g., PRT channel and TC channel), a message appears indicating that the in
-
put types are incompatible and the copy function fails. User channels can be
used to temporarily store any type of channel.
1560 Thermometer Readout
User’s Guide
44
To Next Page
Loading...
