Safety Information
This meter has been designed and tested in accordance with IEC
Publication 348. To ensure that the meter is used safely, follow all safety
and operating instructions in this manual. If the meter is not used as
described in this manual, the safety features of the meter might be
impaired.
•
Do not use the meter if the meter or test leads look damaged, or if you
suspect that the meter is not operating properly.
•
Turn off power to the circuit under test before cutting, unsoldering, or
breaking the circuit. Small amounts of current can be dangerous.
•
Do not apply more than 500V rms between a terminal and earth ground.
•
Use caution when working above 60V dc or 30V ac rms. Such voltages
pose a shock hazard.
•
When using the probes, keep your fingers behind the finger guards on
the probes.
•
Disconnect the live test lead before disconnecting the common test lead.
Symbols
The following international symbols are used in this manual:
Important Safety Information in Manual
AC
DC
Diode Test
Ground
Fuse
Indicates Terminals At Which Dangerous Voltages May Exist
Battery
To Next Page
Loading...
