8060A
Instruction Manual
2-24
A quick way to check for shorted or open junctions is to reverse the test
leads. If the junction indicates the same in-scale reading both directions, it is
probably shorted. If the junction indicates an overrange both directions, it is
open.
2000mA
2000nS
A
A
COMMON
V Ω S
V
Ω
S
200mA
200
200k
200µA
DC
AC
Hz
200mV
200Ω
20mA
20
20k
2mA
2
2k
1000 DC
750 AC
MΩ
Hz
dB
REL
1000V DC
750V AC
MAX
2A MAX
500V MAX
!
!
Relative (REL)
Relative (REL)
Button
Low (-)
High (+)
1.
Select range and function
(any measurement function:
V, A, Ω, S, Hz, dB or ).
2.
Heed input overload limits (Table 2-2),
connect test leads and take desired
measurement (example shows a 1.5000V
measurement has been taken and displayed):
3.
Press the REL button to store the next measured value
as relative reference (display becomes zero and the REL
indicator is displayed). The stored reference is subtracted
from subsequent measurements:
4. To cancel the relative reference, press REL.
The REL
indicator disappears and the original measurement
value is reestablished:
dx18f.eps
Figure 2-17. Relative (REL) Operation
To Next Page
Loading...
