Fluke 831 - Page 80

Tap to confirm changing Live Move planes. The sensor- reflector position selec-
tion screen appears.Proceed to position the displayed sensor as described previously.
Loosen the anchor bolts. Move the machine feet in the direction of the color coded bold arrows
to correct the alignment condition. Keep an eye on the smiley on the display screen. The color
coded bold arrows signify the attained coupling tolerance as follows: Blue (excellent con-
dition); Green (acceptable condition) and Red (poor condition). The color of the arrows
changes with the movements automatically. Watch the display screen carefully to ensure that
machine end and direction moved are correct. The smiley on the display screen gives an indic-
ation of the alignment status as the machine is moved.
Machines should be moved to within acceptable tolerances ( ) or excellent tolerances ( )
while observing shaft alignment best practices.
CAUTION
Do NOT attempt to move the machine using heavy sledgehammer blows. This can cause
bearing damage, and also produce inaccurate Live Move results. Jack bolts on the feet
or other mechanical or hydraulic devices are recommended to move machines.
l
(1) Tap the 'Cancel' icon to prompt the 'Cancel Move' hint.
l
(2) Tap the 'Proceed' icon to start Live Move again or to remeasure the
machines.
If the laser beam is centered, tap to start Live Move automatically.
80 Version:
1.0
On-board help
Shop for Fluke products online at:
1.888.610.7664
www.MyFlukeStore.com