Introduction and Specifications
Introduction 1
1-3
Introduction
The Fluke 8808A Digital Multimeter (hereafter referred to as the Meter) is a 5-1/2 digit
dual-display multimeter designed for bench-top, field service, and system applications.
The multiple measurement functions, plus the RS-232 remote interface, make the Meter
an ideal candidate for precision manual measurements and use in automated systems. For
portability, the Meter includes a carrying handle that also serves as a bail for bench-top
operation.
Some features provided by the Meter are:
• A dual vacuum fluorescent display that allows two properties of an input signal to be
displayed at the same time (e.g., ac voltage in one display and frequency in the other)
• 5-1/2 digit resolution
• True-rms ac
• 2, 4 wire resistance or patented 2x4 wire resistance measurement technique
• 200 mV to 1000 Vdc range with 1 μV sensitivity
• 200 mV to 750 Vac rms with 1 μV sensitivity
• 200 Ω to 100 MΩ with 1 mΩ sensitivity
• 200 μA to 10 Adc with 1 nA sensitivity
• 20 mA to 10 Aac with 100 nA sensitivity
• Frequency measurements from 20 Hz to 1 MHz
• Continuity and diode test
• Measurement rates of 2.5, 20 and 100 samples/second (slow, medium and fast,
respectively)
• Front-panel setup key for single key access to saved setups
• A compare mode to determine if a measurement is within defined limits
• Remote operation via the RS-232 interface
• Closed-case calibration (no internal calibration adjustments)
Manual Set
The manual set for this Meter consists of a printed Getting Started Manual and a Users
Manual on a CD-ROM. The Getting Started Manual contains basic getting started
information, contacting Fluke, unpacking, and general specifications.
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.ca
To Next Page
Loading...
