Preparing the Meter for Operation
Cleaning the Meter 2
2-9
To prepare the Meter for rack mounting, remove the bail and remove the front and rear
protective boots. To remove a boot, stretch a corner then slide it off as shown in Figure 2-
5.
To install the Meter into the rack, refer to the instructions provided with the Rack Mount
Kit.
eue22.eps
Figure 2-5. Boot Removal
Cleaning the Meter
XW Warning
To avoid electric shock or damage to the Meter, never get water
inside the Meter.
W Caution
To avoid damaging the Meter’s housing, do not apply solvents
to the Meter.
If the Meter requires cleaning, wipe it down with a cloth that is lightly dampened with
water or a mild detergent. Do not use aromatic hydrocarbons, alcohol, chlorinated
solvents, or methanol-based fluids when wiping down the Meter.
Fluke 45 Emulation
To switch the Meter to Fluke 45 emulation:
Press and hold S and f for two seconds.
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.ca
To Next Page
Loading...
