Operating the Meter from the Front Panel
Introduction 3
3-5
Table 3-1. Front-Panel Features (cont.)
No. Name Description
I J Primary operation: Sets the Meter’s measurement rate to slow,
medium or fast
Second level operation: Selects source for triggering
measurement
J I Primary operation: Selects Touch Hold function
Second level operation: Sets Touch Hold minimum response
level
K T Primary operation: Selects relative readings function to display
difference between relative base and input
Second level operation: Sets relative base
L W Primary operation: Selects dB measurement mode
Second level operation: sets dB reference impedance
M N Stores the minimum and maximum inputs measured
N
F
D
A
E
B
O
G
Selects measurement function:
Frequency
DC voltage
AC voltage
DC current
AC current
Resistance (ohms)
Continuity / diode test (toggles)
O R Toggles between manual and autorange modes
Uand V increase and decrease the range for manual
ranging
P 10 A Input terminal for 10 A ac and dc current measurement
Q mA Input terminal for 200 mA ac and dc current measurement
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.ca
To Next Page
Loading...
