Fluke 8808A - Page 41

Operating the Meter from the Front Panel
3
3-7
Table 3-2. Display Annunciators and Indicators
No. Name Description
A
r
Meter is in remote mode (remotely controlled)
B
L
the front panel is locked out
C
Ext Trig Meter is in external trigger mode
D
S Q is pressed and secondary function will be selected
E
REL
X Relative readings function modifier is selected
F
–
Measurement value in secondary display is negative
G
H
Touch Hold function modifier is selected
H
M
Minimum maximum function modifier is selected
I
MAX and MIN Reading is maximum or minimum
J
AC DC Form of voltage displayed in secondary display
K
2x4 Wire
Resistance measurement method selected (2-wire or 4-
wire)
L
mV µmA kHz Mke Unit of measurement displayed in secondary display
M
R G
Continuity test or diode test is selected
N
mV µmA Mke kHz Unit of measurement displayed in primary display
O
AC DC Form of voltage displayed in primary display
P
Slow, Medium, Fast Measurement rate selected (slow, medium, fast)
Q
–
Measurement value in primary display is negative
R
Setup 8 annunciator Which configuration is currently selected
S
Print Meter is in RS-232 print-only mode
T
* (asterisk) Flashes for each Meter sample cycle
U
Auto Range Meter is in auto range mode
V
Manual Range Meter is in manual range mode
W
CAL Error Calibration attempt failed
X
Y
High voltage is detected
Displays when voltage is >30 V dc or ac rms
Shop for Fluke products online at:
1.877.766.5412
www.MyFlukeStore.ca