A plastic locking tab is provided on each disk for
write-
protection. When a disk is write-protected, data can be read
from but not written to the disk. To write-protect a disk, slide
the tab over so that you can see through the window in the disk
case.
PREPARING TO TEST OR TROUBLESHOOT
1.4.
When preparing to test or troubleshoot, you will probably go
through a routine such as the one summarized below. Section 4
of this manual contains more complete description of the
self-
test, configuration and calibration processes.
1.
Power-up the system.
2. Perform self-tests on the pod, the probe, and each
I/O module used.
3.
Check that the right disk drive has been selected.
See Section 2.3 of this manual.
4. Configure the system by restoring a configuration
from the user disk.
5.
Calibrate the system or restore calibration data stored
on the user disk.
l-6
-
To Next Page
Loading...
