-
Section
7
Simulating UUT Operation
(RUN UUT Key)
Use the RUN UUT test to simulate normal UUT operation. The
pod’s microprocessor executes instructions found in UUT
memory, starting at a specified address. Beyond lending the
pod microprocessor to the UUT, the
91OOA/9105A
system does
not interfere in the operation.
Starting this test involves pressing the RUN UUT key, the
SPECIAL
softkey,
checking the default starting address, and
pressing the ENTER key. If your pod allows breakpoints, you
can use the BREAK
softkey,
before using the ENTER key, to
specify a breakpoint.
The pod does not return control of the UUT to the 9
lOOA/9105A
system unless a specified breakpoint address (exit) is encoun-
tered or the RUN UUT HALT command is entered while RUN
UUT is in progress.
7-1
To Next Page
Loading...
