Fluke 9100A - Changing to a New Type of UUT; Changing 9100 A;9105 A System Devices

CHANGING TO A NEW TYPE OF UUT
After you test or troubleshoot one type of UUT and are ready for
another type, you will typically follow the procedure shown
below. Section 4 describes self-tests, configuration, and
calibration.
1.
Perform self-tests on any new pod, probe, or I/O
module added to the system.
2.
Change user disks if the new UUT directory is on a
different user disk.
3. Recalibrate the system if the new UUT uses a new
pod or extra I/O modules.
4. Restore the configuration for the new UUT from the
user disk.
CHANGING 9100A/9105A SYSTEM DEVICES 1.7.
If parts of the system such as the pod, probe, or J/O modules are
changed, you should follow the procedure below. Section 4
describes self-tests, configuration, and calibration.
1.
Perform self-tests for the new devices.
2. Recalibrate the system.
l-8
-