Fluke 9100A - Stopping a RUN UUT Test

The MORE INFORMATION light may come on if
the command is so long that you have to use the right
arrow key to view the next field.
5. Press the ENTER key to enter the command.
STOPPING RUN UUT 7.2.
After you execute a RUN UUT command, the pod takes control
of the UUT and does not return control to the 9100A/9105A
unless you execute RUN UUT HALT.
To stop a typical RUN UUT test:
1. Press the RUN UUT key and use the left arrow key
to move the cursor to the left-most field.
2. Press the HALT softkey. The display should now
read:
RUN UUT HALT
3. Press the ENTER key to enter the command.
7-3