Getting Started with CableManager Software
Using the Sample File
B
B-3
Using the Sample File
If you don’t have any test data, but want to practice using CableManager, you can
use the sample file included with CableManager software. The file is copied to
your CableManager directory during installation. See the section “Opening an
Existing Project”.
Connecting the Memory Card Reader to a PC
To use the memory card reader to upload Autotest reports from a memory card to
a PC, connect the reader to the PC as shown in Figure B-1.
The drivers for the card reader are installed on the PC when you install
CableManager.
Memory Card
Reader
PC Keyboard
Connector
PC Keyboard
12345678
PC
PC
Parallel
Port
Parallel Printer
Cable (if used)
Parallel Printer
(if used)
Memory Card
oy14f.eps
Figure B-1. Connecting the Memory Card Reader to a PC
To Next Page
Loading...
