Fluke NetTool User Manual

5
Cable Testing
You can check cable length, detect split pairs, or use
the wiremap adapter (supplied PN 1563930) to verify
pin-to-pin continuity from the near to the far end of a
cable.
Cable Test
⇒ Plug the cable to test
into the jack on either
side of the NetTool.
Power up NetTool.
AutoTest flashes.
Press Select.
⇒ Highlight the Spool icon
and press Select to
see cable status.
NetTool detects cable
length, opens, shorts,
and split pairs.
⇒ This applies for patch
cables as well except
you would plug both
ends in to the NetTool
and then press Select.
afq31s.bmp
afq32s.bmp

Fluke NetTool Specifications

General

Display	LCD
Interface	RJ45
Network Discovery	Yes
Connectivity Testing	Yes
Switch Port Identification	Yes
Power over Ethernet (PoE) Detection	Yes