Section IV - Program Mode
MN06065 Rev. 0.3 (8/97) 35
Program Subdirectory Selection
Once in the Program Mode of the main directory the
subdirectory can be accessed either by their three
digit code or by pressing “SET” twice, which will en-
ter the instrument into the first program subdirectory.
The other directories can then be stepped through
sequentially by continuing to press “SET”.
Specific Subdirectory Selection
To enter the directory using its three digit program
code, the following steps must be used:
1.
The following prompt is displayed on the left dis-
play when entry is made into the Program Mode.
The right-hand display will display the directory
you are working in and is not shown in the fol-
lowing procedures.
Enter Dir or Program #
2.
Enter the subdirectory number required (i.e.,
200).
Enter Dir or Program 200
Note:
If an error is made when entering the number of the directory
required, the “CLEAR” button can be pressed to the clear the
wrong number and a new number can then be entered.
3.
Press “ENTER”.
200 Flow Control Dir
4.
Press “CLEAR” to get to the exit prompt.
Press Enter to Exit Dirs
5.
Press “CLEAR” again to get to the directory en-
try prompt.
Enter Dir or Program #
6.
Enter the new directory number (i.e., 400).
Enter Dir or Program 400
7.
Press “ENTER”.
400 Temp & Density Dir
Sequential Subdirectory Selection
To enter the subdirectory and use the “SET” button
to sequentially step through the subdirectories, the
following steps must be observed:
1.
The following prompt is displayed when entry is
made into one of the main directories:
Enter Dir or Program #
2.
Enter the subdirectory number required (i.e.,
100).
Enter Dir or Program 100
Note:
If an error is made when entering the number of the directory
required, the “CLEAR” button can be pressed to clear the wrong
number and a new number can then be entered.
3.
Press “ENTER” and the first subdirectory will be
displayed:
100 General Purpose Dir
4.
Press “SET” and the second subdirectory will be
displayed:
200 Flow Control Dir
5.
Press “SET” again and the third subdirectory will
be displayed:
300 Volume Accuracy Directory
Repeat step 5 until the subdirectory required is
reached.
To Next Page
Loading...
Need help?
General
