Section V - Program Codes
46 MN06065 Rev. 0.3 (8/97)
Code Description
211 Valve Delay to Open
212
Zero Flow Alarm
Note: This code applies to RBU-08 and above firmware.
213-239 Unassigned at Present
240 Protection of Program Codes 280-289
241-279 Unassigned at Present
280 Clean Line Product
281 Clean Line Volume
282 Clean Line Alarm Limit
283 Ratio Adjustment Factor
284 Ratio Adjustment Timer
285-299 Unassigned at Present
300 System Volume Accuracy Directory
301 Transaction Control
302 Maximum Preset Volume
303 Minimum Preset Volume
304 Auto Preset
305 Auto Preset Increment
306 Blank Downcounter
307 Volumes for Local Storage
308-339 Unassigned at Present
340 Protection of Program Codes 380-389
341 Display Units
342 Corrected Display Indicator
343 Display Resolution
344 Proving Modes
345 Proving Output
346 Proving Output Units
347 Recipes Per Transaction
348 Blend Tolerance (Percentage)
349 Blend Tolerance (Volume)
To Next Page
Loading...
Need help?
General
