42
G BG B
G BG B
G B
BLITZ
SEMI-AUTOMATIC CUTTING (‘STEP-BY-STEP’ CYCLE) (OPTIONAL)
Turn selector “1” - Fig. 06-03 to activate the ‘SEMI-AUTOMATIC’ cutting mode’.
Set the required cutting measurements on the equipment (see the enclosed manual).
Once the vices have been clamped, consent to start the ‘step-by-step’ cutting program is given by pressing
at the same time (and keeping them pressed down for the whole duration of the program) buttons ‘3’ - Fig. 06-
02.
If one or both the buttons are released, the ‘step-by-step’ cycle stops and starts again (from the point where
it was interrupted) only when both buttons are pressed again.
N.B. ‘Step-by-step’ cutting can be done in the automatic cycle mode (the program starts with an impulse
command), instead of the bi-manual control with continuous action, using a photocell barrier (OPTIONAL)
to protect the front of the machine (for further information, refer to the booklet “Photocell kit for step-by-
step program” enclosed with this manual).
To Next Page
Loading...
