3
BLITZ
G BG B
G BG B
G B
1 GENERAL WARNINGS
Before putting the machine into service all the technical instructions given in this manual must be observed
and all the indications shown must be scrupulously followed.
This manual and all the literature enclosed with it must be kept in an easily accessible place known to all
operators and staff entrusted with maintenance operations.
1.1 INTRODUCTION
The BLITZ has been specifically designed for sawing profiles in aluminium or light alloy.
The machine has been specifically designed to be used by a single operator.
WORKING PRINCIPLE:
- Once a profile is placed on the work tables of the two heads, a pneumatic circuit activates the horizontal
and vertical vices that clamp the profile in place.
- Two motors drive the rotational movement of the respective saw blades. Operated by buttons on the control
console, the blades come out, cut the profile and return automatically.
- Cutting is possible at external angles from 90° to 12° for BLITZ 55 (10° for BLITZ 50, 20° for BLITZ 60L)
and from 90° to 45° internally.
- When cutting is complete the vices open again to allow another profile to be positioned for the next cut.
The instructions for the various pieces of electronic equipment supplied with the models which BLITZ can be
used with are enclosed with this instruction manual as separate publications.
1.2 WARRANTY
The company guarantees that this machine has been tested under peak running conditions with excellent
results. This warranty is valid for a period of 12 months and covers construction materials and defects only.
The customer has only the right to claim for replacement of faulty parts, excluding the cost of carriage and
packaging and complete machine replacement. This warranty does not therefore cover any damage caused
by dropping, tampering or improper machine operation, by disregard of maintenance instructions given in the
instruction manual, or by faulty handling by the operator. No compensation may be claimed for any periods of
machine inactivity. This warranty is not binding unless all payment conditions have been met.
The cost of service assistance, together with the cost of spares used is not covered by the warranty. These
must be paid directly to the service technician who will issue a maintenance slip to be later followed by a regular
invoice.
Maintenance charges and the cost of the spares used are taken from the Price List in force at the time.
To Next Page
Loading...
