15
4-2 Picatinny Rail Mount/IR Port
The X24 includes a picatinny rail mount located on top of the caller (rail
not included). To install the rail, remove the 2 set screws that are
included with the caller. Mount the rail so the holes line up and re-
install the screws. You can now attach accessories that utilize a
picatinny rail.
Beside the mount, you will see a small lens. This is the IR port for use
with X-Decoy (sold separately). If you have an X-Decoy attached to your
caller (see decoy’s instructions for mounting), when you press the
remote button to control the auxiliary function, this port will send a
signal to the X-Decoy to start and stop the motion of the decoy,
eliminating the need to connect the decoy to the caller with an external
cable. Note: Early versions of the X24 do not have an IR Port and
require the use of an auxiliary cable to connect to the X-Decoy
4-3 External Speaker Jack Information
The X24 features an external speaker jack. This jack is a standard
3.5mm female jack that can accept a 3.5mm male plug. When selecting
an external speaker to use with the X24, note that FOXPRO
recommends the use of a 15W speaker with 8Ω Impedance.
FOXPRO carries a variety of external speakers for purchase that can be
used with the X24. You can view the line of speakers online by visiting
www.gofoxpro.com
Connect an external speaker to Your X24:
Make sure that the X24 is powered off before connecting to an external
speaker. Connect the plug from the external speaker to the external
speaker jack. Turn on the X24 and begin playing a sound to hear the
external speaker in action.
To Next Page
Loading...
