Foxpro X24 - FOXGRIP

28
Proceed forward with your hunt and use the caller just like you
normally would. Each time you wish to create a log entry, push the
FOXDATA button a single time and the current state will be recorded.
After you have completed the hunt, push the FOXDATA button for 1-2
seconds and select one of the shown options to close the session with a
specific comment reflecting the outcome of the hunt.
The options for ending a hunt are as follows: Successful Call, Successful
Call/Kill, Shots Fired / Miss, Camera Shot, Nothing Seen, Premature
Ending. The options for weather conditions are as follows: Weather
Clear, Weather Cloudy, Weather Overcast, Weather Rain, Weather
Snow.
6-6 FOXGRIP
This allows you to pair a FOXPRO Fox Grip or Fox Grip 2 with the X24
Remote control. Detailed instructions for using each Fox Grip model can
be found on our website. The following provides general instructions
for basic setup.
Pairing the FOXGRIP to your X24 Remote:
Make sure that your FOXGRIP has a fresh battery installed. Access the
FOX FEATURES menu and locate the FOXGRIP Unit ID menu option.
Push the “Play/Select” button a single time. A message will appear
stating “Activate FOXGRIP to pair now.” Push the button on your
FOXGRIP. The X24 remote will detect the signal and then display the
FOXGRIP Unit ID to the right of the menu item.
After the FOXGRIP device is paired with your X24 remote, the next step
is to determine what feature you would like to assign to FOXGRIP. The
following options are available: FOXDATA, mute, auxiliary, preset 5,
preset 4, preset 3, preset 2, and preset 1. To disable FOXGRIP, set this
to off.