35
10-7 About Info
The About Info screen displays a variety of information pertaining to
version number, number of sounds loaded, number of FOXCAST
sequences loaded, number of categories loaded, and the number of
presets.
10-8 Restore Defaults
To reset your X24 remote control back to factory defaults, use this
option. Please be aware that restoring factory defaults will result in loss
of your presets/favorites, sound list, categories, and all FOXDATA
information.
Restoring Factory Defaults:
Access the TX1000 Settings menu and select “Restore Defaults”. A
confirmation screen is displayed asking you if you are sure. To proceed,
select “Yes”, otherwise, “No” will return you to the menu. Once the
reset is complete, the remote will be back to factory default conditions.
11. X24 Remote USB Operation
The X24 remote control features a mini-USB port located inside the
speaker cap compartment. To connect the remote to a computer, you
will need to obtain a mini-USB type A/B cable. Before connecting the
X24 remote to a computer, be sure that the remote has fresh batteries
installed. The X24 remote must be powered on while connected to a
computer. If the remote loses power while it is connected to a
computer during a write-mode, there is a possibility of corruption of the
file system. Make sure the batteries are fresh to prevent any damage
from occurring.
Connecting the X24 Remote to a Computer:
Connect the USB cable from the jack on the X24 remote to a USB port in
the computer. Power on the X24 remote. The screen should activate
and show “USB Active” instead of the sound screen.
To Next Page
Loading...
